In this project, two LEDs should blink alternating between them once a button is pressed. Otherwise, both LEDs should stay ON.
- Button not pressed: LED A, B ON
- Button pressed: LED A ON, LED B OFF for 1sec, and then the opposite
Initial project state
Click on the link below and complete the wiring of the circuit.
Link: Part 1: Wiring
Now, you can move on to start writing your program and testing your sensor. Click on the link below and complete the calibration and configuration of the circuit.
Link: Part 2: Calibration
Lastly, and most importantly, you have to create the logic to make your circuit behave as needed for the project. Click on the link below and complete the logic of the circuit.
Link: Part 3: Logic